Spl - Set Page Length - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
SPL —
Set Page Length
Format
Parameter
length:
Function
File
320
SPL length;
distance from top margin to bottom margin
The SPL command sets the bottom margin, as measured from the top margin position in
the unit value designated by the UNIT command.
If an attempt is made to print below the bottom margin, the characters are printed on the
next page.
A page length setting in a document file should be placed at the beginning of the file or at
a page break.
The SBM (Set Bottom Margin) and SLPP (Set Lines Per Page) commands also set the
bottom margin.
!R! RES; UNIT C;
SFNT "TimesNewRoman";
STM 1; SLS 1; SPL 10;
EXIT, E;
Top margin at 1 cm, with 10 cm page length. (Line 1)
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
!R! PAGE; EXIT;