Sbm - Set Bottom Margin - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
SBM —
Set Bottom Margin
Format
Parameter
length:
Function
File
264
SBM length;
distance from top of paper to bottom margin
The SBM command sets the bottom margin, as measured from the top edge limit of the
paper in the units designated by the UNIT command.
If an attempt is made to print below the bottom margin, the characters will be printed on
the next page.
A bottom margin setting in a document file should be placed at the beginning of the file
or at a page break.
The SPL (set page length) and SLPP (set lines per page) commands also set the bottom
margin, but these commands measure from the top margin position.
!R! RES; UNIT C;
STM 1; SLS 1; SBM 11;
SFNT 'Helvetica-Nr';
EXIT, E;
Top margin at 1 cm, bottom margin at 11 cm. (Line 1)
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
!R! PAGE; EXIT;