Altb S - [Allocate Table] Start To Define The Combination Character; Altb S; [Allocate Table] Start To Define The Combination Character - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
ALTB S —
Format
Parameters
table-id:
code:
width:
height:
x-coordinate:
y-coordinate:
paint-mode:
Function
20
[ALlocate TaBle] Start to define the
combination character
ALTB S, table-id, code[, width, height[[, x-coordinate, y-coordinate,
[paint-mode]]];
number identifying the character table to define the combination character, from 1 to
65535
character code for which the combination character is defined. 1-byte code = 0 to 255;
2-byte code = 0 to 65533, or in hexadecimal notation ($xxxx).
overall width of the combined character, represented by number from 1 to 65535 in units
where the width of the resident font character is 1000
overall height of the combined character, represented by number from 1 to 65535 in units
where the height of the resident font character is 1000
X coordinate of the reference point, integer value converted in reference to 1000 units
Y coordinate of the reference point, integer value converted in reference to 1000 units
paint mode: 0 = normal (filled), non-zero = line width of outline character (stroked):
1 to 100 units
This command starts to define the combination of characters by specifying the region
and coordinates. The characters to combine in this region are registered using the
ALTB T command (page 21). The ALTB S sequence is terminated by the ALTB E
command. If the identical table number already exists, the existing character table is
replaced with the new character table.