Clip - Clip Current Path - Kyocera DP-1800 Command Reference Manual

Prescribe commands command reference manual rev 4.8

Hide thumbs Also See for DP-1800:

Table of Contents

PRESCRIBE Command Reference

CLIP current path

CLIP [clip-mode];

2: Non-zero winding clip

The CLIP command sets the current path as the clipped path. After this command is

issued, no painting is done outside the area of the path. Executing this command does not

delete the current path.

The RES command initializes paths to a state with no clip area.

Show Quick Links

Chapters

Table of Contents