Rwer W - [Read/Write External Resource] Write Data To External Media - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
RWER W —
Format
Parameters
medium:
data-type:
partition-name:
Function
250
[Read/Write External Resource] Write
data to external media
RWER W, medium, data-type[, 'partition-name'];
0 = hard disk or RAM disk
A = memory card
1 = Font data
2 = Printable data
16 = Macro data
112 = File data
128 = API data (downloadable program)
Name of partition to which data is written, in a maximum of 15 printable ASCII
characters. If this parameter is omitted the printing system will automatically determine
the partition name.
The RWER W command writes data to any external media whether it is a memory card
or the hard disk.
Although all data types may be written up to the amount allowed by the storage size of
the given media, note carefully that writing beyond this limit will result in data being
interpreted as unneeded.
Even if data is written to a device using the same file name, that data will be written
without overwriting the original file. A partition list will be printed as a warning when
this happens.
A command error results and the command has no effect if parameters other than the
above are used.
This command causes a page break and prints a write information page when executed.
The following example demonstrates how to send data from the computer to a memory
card. Typically, partition names should be specified when writing to the card. If omitted,
the partition names will be assigned automatically as follows:
DataS001, DataS002 ... DataSnnn.
Writing data to a memory card:
To write the contents of file DATA123.DOC to partition DATA123 on the memory card: