Table of Contents
Advertisement
Using the Printer
56
Setting the Sleep Timer
The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments.
Setting the sleep timer to 0 turns it off. The sleep timer is set at the factory to 60 minutes.
To set the sleep timer:
1
Press the MODE key on the printer panel.
2
Press the + key repeatedly until the message display indicates
Others>.
3
Press the
key.
4
Press the + key repeatedly until the message display indicates
>Sleep timer.
The current sleep timer (in minutes) is indicated.
5
Press the ENTER key. The question mark (?) will appear.
6
Press the + or - key to change the timer setting. You can use the
key to quickly change the timer setting.
7
Press the ENTER key to finalize the setting.
8
Press the MODE key to exit the mode selection menu.
Once the set time arrives, the printer will display Sleeping and all indicators will go
out. This minimizes the amount of energy used.
Note:
To have the printer enter sleep mode a set period of time after printing, press the
CANCEL key one time while the display reads Ready. The printer will enter sleep
mode after about five seconds. Note however that sleep mode will not result if the
sleep timer setting is set to 0.
Resource Protection
When you switch from the PCL 5C emulation to KPDL, all downloaded fonts and macros
are lost. Resource protection preserves these PCL resources in memory so that they are
intact when you change the emulation back to PCL 5C.
By using the printer's >Resource prot.menu, you can select from two resource
protection modes:
or
Advertisement
Table of Contents
