Message Command: Points To Note; Message Command Example - Xerox DocuPrint 100 Software Manual

MESSAGE OTEXT:
points to note
OUTPUT COPIES= 4;
MESSAGE OTEXT= ('LOAD BLUE PAPER',2,WAIT),
OTEXT= ('LOAD WHITE PAPER',3,WAIT),
OTEXT= (('LAST COPY DONE', 'RELOAD STANDARD PAPER'),
Using LCDS Print Description Language
• Multiple line messages may be specified for a single copy by
one of the following methods:
– Specifying the copy number more than once in different
OTEXT parameters
– Specifying a list of string constants contained in a second
level of parentheses.
• A maximum of 395 messages is permitted per report.

MESSAGE command: points to note

• You can use the # sign as a case toggle to switch between
upper- and lowercase when entering the messages.
• Messages may be entered in hexadecimal, octal, ASCII, H2,
H6, or EBCDIC. You must enter an apostrophe (') followed by
the appropriate letter for the language. (If there are no
introductory symbols, the message defaults to EBCDIC.)
Refer to the "Types of string constants" table in the "PDL
principles and procedures" chapter for further information.

MESSAGE command example

The following MESSAGE command informs the operator that
blue paper is required for copy 2 of a 4 copy report. Printing is
suspended at the appropriate points so that the operator can
load the paper.
END, WAIT);
Specifying print format parameters
4-41