Rstack Command Example - Xerox DocuPrint 100 Software Manual

T1: TABLE
C1: CRITERIA
Using LCDS Print Description Language
• Detection of RSTACK immediately following report
separation is ignored. This prevents null reports. If RSTACK
is specified in a selected JDE or JDL, that is, a JDE or JDL
invoked in a DJDE), the following restrictions apply to online
systems:
– If RSTACK is not specified in the JDE or JDL that is
identified in the Initial JDE or JDL field on the user
interface window, the DELIMITER=NO parameter should
be specified in the selected JDE or JDL. Specification of
DELIMITER=YES is overridden in this case.
If RSTACK is specified in the Initial JDE or JDL, the
DELIMITER parameter cannot be changed in a selected
JDE or JDL.
– If RSTACK is specified in the starting JDE or JDL but not
in the selected JDE or JDL, RSTACK processing is
suspended until end of report is triggered by BANNER
page detection.
– If ACCTINFO is specified in the Initial JDE or JDL on the
Online Job Manager window, the ACCTINFO parameter
cannot be changed or deleted in a selected JDE or JDL
(even if RSTACK is suspended).
If ACCTINFO is not specified in the Initial JDE or JDL, it
can be invoked in a selected JDE or JDL. The first record
after the selected JDE takes effect is then printed as the
ACCTINFO field.

RSTACK command example

Following is an example of the RSTACK command:
CONSTANT=('XEROX');
CONSTANT=(1,5,EQ,T1);
RSTACK TEST=C1, DELIMITER=YES,
ACCTINFO=(14,19),
HRPTNA=(20,10);
In the previous example, reports are separated by a record with
the characters XEROX in bytes 1 to 5 (relative to 0). Two reports
are created as illustrated in the following figure. The delimiter
record is not printed with the report.
The following figure illustrates a sample RSTACK command
usage.
Using logical processing
3-59