Line Blanktype - Xerox DocuPrint 100 Software Manual

Specifying print format parameters
Options
Table 4-25. LINE BASELINE parameter options and definitions
Option
TOP
CENTER
BOTTOM
LARGE[ST]
Default
LINE BASELINE
parameter: point
to note
Syntax
Options
Table 4-26. LINE BLANKTYPE parameter options and definitions
Option
F
V
SPACE
NOSPACE
Default
4-24
Definition
Determines the baseline position from the top of each line by using the
BASELINE parameter of the first font in the PDE font list.
Positions all of the characters so that their center lines match.
Determines the baseline from the bottom of each line by using the
BASELINE parameter of the first font in the PDE font list.
Determines the baseline position and the line spacing by using the largest
font in the PDE font list.
LARGE[ST]
If KANJI is specified as one of the fonts (KANJI = YES), a
BASELINE=LARGE command is treated as BASELINE=TOP.

LINE BLANKTYPE

Specifies whether or not the "shift in" and "shift out" function
codes are printed as spaces.
LINE BLANKTYPE = {F | V | SPACE | NOSPACE}
Definition
Specifies the width of the back space character that is associated with the
width of the full-sized single-byte character, or of the half-sized double-byte
character.
Specifies the width of the back space character that is associated with the full-
sized single-byte or double-byte character.
Replaces X'0E' and X'0F' ("shift-in" and "shift-out") function codes with single-
byte blank character spaces.
Specifies that no space code is substituted.
NOSPACE
Using LCDS Print Description Language