Minitower Expansion Board Installation; Minitower Expansion Slots - NEC POWERMATE 4100M Service Manual

5. Reinstall the expansion slot screw to secure the expansion board.
6. Connect any expansion board cables.
Replace the top cover.
7.

Minitower Expansion Board Installation

Install expansion boards into the minitower system unit as follows.
1. Remove the top cover as previously described.
Remove the expansion slot screw and cover (see Figure Section 3-14). Save the
2.
expansion slot cover in the event the expansion board is removed in the future.
*Half-length slot: other slots are full-length.
Figure Section 3-14 Minitower Expansion Slots
Install the expansion board into an expansion slot connector. When installing a
3.
full-size expansion board, make sure that the expansion board slides into the guide
rail at the front of the system unit.
Reinstall the expansion slot screw to secure the expansion board.
4.
5. Connect any expansion board cables.
6. Replace the top cover.
ISA/VL-Bus Slot
ISA Slot*
Options 3-7
ISA Slots