The Session Limit Edit Screen; Figure 257 Firewall > Session Limit > Edit; Table 121 Firewall > Session Limit > Edit - ZyXEL Communications ZyWALL USG 100 Series User Manual

20.3.1 The Session Limit Edit Screen

Click Firewall > Session Limit and the Add or Edit icon to display the Firewall Session
Limit Edit screen. Use this screen to configure rules that define a session limit for specific
users or addresses.
Figure 257
The following table describes the labels in this screen.
Table 121 Firewall > Session Limit > Edit
LABEL
Enable Rule
Description
User
Address
Session Limit per
Host
OK
Cancel
ZyWALL USG 100/200 Series User's Guide
Firewall > Session Limit > Edit
DESCRIPTION
Select this check box to turn on this session limit rule.
Enter information to help you identify this rule. Use up to 64 printable ASCII
characters. Spaces are allowed.
Select a user name or user group to which to apply the rule. Select Create Object
to configure a new user account (see
rule is activated only when the specified user logs into the system and the rule will
be disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source address.
Use this field to set a limit to the number of concurrent NAT/firewall sessions this
rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default Session per
Host setting in the general Firewall Session Limit screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Chapter 20 Firewall
Section 36.2.1 on page 606 for details). The
357