Nortel Meridian Meridian 1 Feature Description And Administration page 1703

Feature implementation
LD 27 – Administer the Terminal Service Profiles (TSPs) on a Digital Subscriber Loop (DSL)
Prompt Response
REQ NEW
CHG
TYPE TSP
DSL lll s c dsl#
c dsl#
USID 0-15
SPID aaa...a <cr>
Xaaa...a
...
Task summary list
The following is a summary of the tasks to configure NI-1 BRI Compliance
Enhancements:
1 LD 27 – Administer the Terminal Service Profiles (TSPs) on a Digital
Subscriber Loop (DSL)
2 LD 27 – Configure the NI-1 protocol for a DSL. Refer to the note above
pertaining to selecting the NI-1 protocol on the ISDN BRI terminals.
Description
Add a TSP.
Change a TSP.
Administer the TSP on a DSL.
DSL address, for Options 51C, 61C, 81C.
DSL address, for Option 11C.
User service identifier
Set USID = 0 to configure a default TSP for
non-initializing terminals.
Set USID = 1-15 for initializing terminals, for example, the
M5317TDX.
Service profile ID
aaa...a = any combination of 1-20 alphanumeric
characters.
<cr> = Stops this prompt from being displayed again. A
maximum of 8 valid SPIDs per TSP are allowed.
This prompt appears only if USID = 1-15 (if 0 was
entered for the USID, a SPID is not required). This SPID
must be programmed in the initializing terminal to
associate the terminal with a USID. Refer to the note
which follows on page 1704.
Xaaa...a = removes the specified SPID.
International ISDN PRI Feature description and administration
ISDN BRI features Page 1703 of 1814