Configure Spanning Tree Protocol Port Settings - TRENDnet TPE-TG50ES User Manual

TRENDnet User's Guide
In addition, this section also displays the spanning tree root information.
© Copyright 2018 TRENDnet. All Rights Reserved.

Configure Spanning Tree Protocol port settings

Network > Spanning Tree > RSTP Port Settings
1. Log into your switch management page (see
on page 6).
2. Click on Network, click on Spanning Tree, and click on RSTP Port Settings.
3. Review the settings. For each entry, click Apply to save changes.

Port: Indicates the port number (1-8)

Port Fast: Select the spanning tree protocol for each port
o
Network: Automatically lets the device determine the type of device
that is connected to the port
o
Disable: Disable port fast on a particular port.
o
Edge: Indicates that this port is connected to an Edge device.
4. In the left hand panel, click on Save
5. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-TG50ES
"Access your switch management page"
17