Setting The Judgment Value - Omron ZG User Manual

Setting the Judgment Value

Setting the Judgment Threshold Value
Set the range of measurement values to be judged as OK.
ADJ mode-MENU/VIEW key-[JUDGE]
Setting value
HIGH
LOW
Note
To change numerical values, use the ↑UP key/↓DOWN key, and to change the number of
digits use the ←LEFT key/→RIGHT key.
Important
The default judgment threshold value is the "rated measurement range of the currently
connected Sensor ÷ 4".
Example:As the measurement range of the ZG-WDS70 (diffuse reflection type) is "60 mm" (±30
mm), the default judgment threshold value becomes "60 ÷ 4=15". So, the default
threshold judgment value is ±15 mm.
Setting the Zero Reset Offset Value
To set a reference value for zero reset to a value other than 0 (zero), set the offset amount
using this function. After setting any target value, execute a zero reset in the RUN mode.
Setting Zero Reset p.56
ADJ mode-MENU/VIEW key-[ZERO]
Setting value
Zero
Note
To change numerical values, use the ↑UP key/↓DOWN key, and to change the number of
digits use the ←LEFT key/→RIGHT key.
ZG User's Manual
Description
Sets the HIGH threshold value.
Range: -999.99999 to +999.99999
Sets the LOW threshold value.
Range: -999.99999 to +999.99999
Description
Sets the offset amount.
Range: -999.99999 to +999.99999 (default value: 0)
Checking/Adjusting the Measurement Status - ADJ Mode
51