Connecting Peripheral And External Devices - Omron ZG User Manual

Note
• Automatic output on the serial interface is not available in continuous measurement.
(Commands only are supported.)
• Before connecting the personal computer to the Controller, start up the terminal software
for acquiring measurement values.

Connecting Peripheral and External Devices

Connecting a PC
Use the USB/RS-232C cable to connect the PC to the Controller.
Important
When connecting devices, refer to the Instruction Manual for the PC.
Connecting by a USB cable
128
Serial Communication
Use the USB cable provided with the ZG-
WDC_1A Controller
Controller to the PC.
Important
Attach the ferrite cores (supplied) to both ends
of the USB cable.
Ferrite core
Note
Installation of the USB driver is necessary
only when connecting an external device to
the USB interface for the first time.
For the USB driver, use the exclusive USB
driver packaged with
controller. Smart Monitor ZG is an accessory
of the ZG-WDC_1A.
to connect the
the ZG-WDC_1A
ZG User's Manual