Error Messages And Corrective Actions - Omron ZG User Manual

Error Messages and Corrective Actions

The following shows error messages that are displayed on the LCD screen and their
corrective actions.
Error message
AUTO SETTING
FAILED
AUTO SCALING DO
NOT OPERATE
AB. THIS ITEM
REFERENCE
REGISTRTION FAILED
NO MEASUREMENT
POINT
SYSTEM ERROR
VDIN END ERR
SCALING
FAILED
SET VALUE ERROR
HIGH, LOW
SET VALUE ERROR
MAX, MIN
CLEAR
BANK DATA
SENSOR IS NOT
(*1)
CONNECTED
*1: When the Sensor is not connected, the Controller screen darkens, making the error message no longer visible.
ZG User's Manual
Probable cause
Automatic setting cannot be executed on the current
region.
Set the region again referring to the manual.
The auto-scaling function does not operate with cross-
sectional area and angle.
Failed to register the reference for position correction.
1. Check whether or not teaching of the profile has been
successful.
2. Check whether or not the edge level has been set
correctly.
There is no measurement target.
Place the measurement target inside the measurement
range.
Communication with the Sensor is not possible.
1. Check the cable connection with the Sensor.
2. Check the cable for breaks.
If there is no problem with the above, a probable cause
is a Sensor or Controller malfunction.
The scaling correction range was exceeded.
Check the input values.
Review the setting values so that HIGH>LOW.
Review the setting values so that MAX>MIN.
When the CCD mode is changed, all bank data is
initialized.
Communication with the Sensor is not possible.
1. Check the cable connection with the Sensor.
2. Check the cable for breaks.
If there is no problem with the above, a probable cause
is a Sensor or Controller malfunction.
Error Messages and Corrective Actions
Reference
p.60
p.71
p.84
p.72
p.33
p.71
p.51
p.91
p.93
p.103
p.157
p.33
179