Input Specifications; Output Specifications - Omron ZG User Manual

Item
Operation Ambient temperature Operating: 0 to +50 °C Storage: -15 to +60 °C
environment
robustness
Ambient humidity
Degree of protection IP20 (IEC60529)
Vibration resistance
(durability)
Shock resistance
(destructive)
Material
Cable length
Weight
Accessories
*1: The measurement cycle stated here is for when the FIXED/AUTO sensitivity modes are selected. The
measurement cycle increases when the MULTI sensitivity mode is selected and according to other settings.
Check the actual measurement cycle by the ECO monitor in the RUN mode.
Controller signal statuses

Input specifications

LD-OFF
ZERO-RESET
TRIG

Output specifications

ALL-PASS
NG
ERROR
GATE
ENABLE
Analog
Parallel Output Unit
*1: For details, see "Chapter 4 CONNECTION WITH EXTERNAL DEVICE" p.109.
170
Specifications and External Dimensions
ZG-WDC11/WDC11A
(with no icing or condensation)
Operating and storage: 35% to 85%
Vibration frequency: 10 to 150 Hz Single-amplitude: 0.35 mm
2
Acceleration: 50 m/s 10 times for 8 minutes
2
150 m/s 3 times each in 6 directions (up/down, left/right, forward/
backward)
Case: Polycarbonate (PC), Cable sheath: heat-resistant PVC
2 m
Approx. 300 g (including cable) (when packaged: approx. 450 g)
ZG-WDC_1: ferrite core (large) (1 p'ce), Insure Lock (1 p'ce), Instruction Sheet
ZG-WDC_1A: ferrite core (large) (1 p'ce), ferrite core (small) (2 p'ces),
Insure Lock (1 p'ce), Instruction Sheet, setup software (CD-ROM), USB
cable
FUN mode ADJ mode
Enabled Enabled
Disabled Disabled
Disabled Disabled
FUN mode ADJ mode
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
Clamp value Clamp value
OFF OFF
ZG-WDC41/WDC41A
RUN mode
Continuous Trigger
(trigger disabled)
Enabled Enabled
Enabled Enabled
Disabled Enabled
RUN mode
Continuous Trigger
(trigger disabled)
ON/OFF ON/OFF
ON/OFF ON/OFF
ON/OFF ON/OFF
ON/OFF ON/OFF
ON ON/OFF
Measurement value/clamp value
Measurement value/status output
ZG User's Manual
(*1)