Position Correction - Omron ZG User Manual

Position Correction

Set the reference position and correction direction to correct position shift of the
measurement target. The measurement value when these are set is registered as the
reference position. So, place the measurement target at the correct position before you
start settings.
Height
correction
Position
correction
Slope
correction
ZG User's Manual
Region for measuring the amount of position shift
Set the area at a position where the height can be
measured as the reference even if the measurement
target moves vertically. The position cannot be
corrected properly if the region contains a protrusion.
Allow sufficient margin when setting the region.
MEAS/REF.POINT
HEIGHT START
[128]LINE SET
Edge detection level for measuring the amount of position shift
Set this level at a location where the target edge can
be detected even if the measurement target moves
horizontally.
MEAS/REF.POINT
POS. EDGELV
[150]LV SET
Region for measuring the amount of position shift
Set to enclose the position where the height of
these two points can be measured even if the
measurement target is inclined.
MEAS/REF.POINT
POINT2 START
[128]LINE SET
Height to be registered as
the reference
Position to be registered
as the reference
Angle to be registered
as the reference
Measurement Settings
83