Error Displays During Numeric Value Setting; Error Displays During Two-Sensor Operation - Omron ZX-LDA11 Operation Manuals

Error Displays
5-1-2

Error Displays during Numeric Value Setting

Display
Attempted to set a numeric value larger than the
HIGH threshold value to the LOW threshold value.
→
(Flashing)
Attempted to set a numeric value smaller than the
LOW threshold value to the HIGH threshold value.
→
(Flashing)
The set numeric value is too large.
(Refer to 5-2-1 to 5-2-4.)
→
(Flashing)
The set numeric value is too small.
(Refer to 5-2-1 to 5-2-4.)
→
(Flashing)
5-1-3

Error Displays during Two-sensor Operation

Display
Two-sensor operation communication data error
→
Unit.
→
for the 1CH Amplifier Unit.
→
(Flashing)
Amplifier Units is normal.
→
if the above countermeasures do not solve the prob-
lem.
One-sensor operation was attempted while selecting
the A − B or A + B operation.
→
the Units and turning OFF two-sensor operation.
(Flashing)
→
is not possible.
Attempted two-sensor operation for two Amplifier
Units with Intensity Mode ON on one Unit and OFF
on the other.
(Flashing) →
(See note.)
Amplifier Units.
Note: The error is displayed only for a Reflective Sensor Head.
Cause and countermeasure
Reset the threshold values, referring to 5-2-3.
Reset the threshold values, referring to 5-2-3.
Input an appropriate numeric value.
Input an appropriate numeric value.
Cause and countermeasure
Select the T or RUN Mode for the 1CH Amplifier
Check whether a incident level error has occurred
Check whether the connection between the
Replace the Amplifier Unit or the Calculating Unit
Perform one-sensor operation by reconnecting
Initialize the settings if the above countermeasure
Use the same Intensity Mode setting for both
Section 5-1
Recovery
Automatic
recovery
Automatic
recovery
Automatic
recovery
Automatic
recovery
Recovery
Automatic
recovery
or replace-
ment
Automatic
reset
Automatic
reset
143