Table of Contents
Advertisement
Setting the correction method
Sets correction ON/OFF in both the height and position directions.
FUN mode-[MEAS]-[CORECT]-[HGT POSN]-[METHOD]
Setting value
NONE (no correction)
HEIGHT (height
correction)
POSITION (position
correction)
HEIGHT&POS (height/
position correction)
ZG User's Manual
MEAS/REF.POINT
POS. EDGELV
[150]LV
SET
MEAS/REF.POINT
SEARCH
DIRECTION
SELECT
←
1L→R 2R→L
MEAS/REF.POINT
EDGE SELECT
SET
Description
The position is not corrected. (default value)
Correction is performed in the height direction.
Correction is performed in the position direction.
Correction is performed in both the height and position directions.
4
To correct shift in the position
direction, align the line of the
edge level to be detected.
Up/Down key: Moves the cursor.
SET: Applies the setting.
ESC key: Cancels the setting.
5
Select the direction in which
edges are searched.
Select [L→R] (forward direction) or
[R→L] (reverse direction).
6
A cross cursor is displayed at the
reference position. Press the ←/→
key to select the edge, and press
the SET key.
Measurement Settings
85
Advertisement
Table of Contents
