Crimp Terminals And Cables; Specifications - Omron F400 Setup Manual

Specifications

3-1

Crimp Terminals and Cables

The terminal block uses M3 terminal screws. Use appropriate crimp terminals for M3
screws, as shown below. Tighten the screws to a torque of between 0.5 and 0.6 N⋅m.
After wiring, check to make sure that the wiring is correct.
WARNING
!
Cover the terminal blocks with the Terminal Block Protection Covers.
Uncovered terminal blocks can result in electric shock.
Forked
6.2 mm max.
Applicable wire size: Insulated wire of 1.31 to 1.65 mm
3-2 Specifications
! WARNING
Use a DC power supply with safe extra low-voltage circuits on the
secondary side. Excessively high voltages can result in electric shock.
Input Specifications
Item
12 to 24 VDC ±10%
Input voltage
ON current 3 to 15 mA
ON voltage 8.8 V max.
OFF current 0.1 mA max.
OFF voltage 4.5 V min.
ON delay RESET input: 10 ms max.
Others:
OFF delay RESET input: 15 ms max.
Others:
Internal circuits
Output Specifications
Item
12 to 24 VDC ±10%
Output voltage
Load current 45 mA max.
ON residual voltage 2 V max.
OFF leakage 0.1 mA max.
current
Internal circuits
16
F400-C10E (NPN model)
0.5 ms max.
0.7 ms max.
COM IN
Input
terminal
F400-C10E (NPN model)
Output terminal
Load
COM OUT
Round
6.2 mm max.
2
F400-C15E (PNP model)
Input
terminal
COM IN
F400-C15E (PNP model)
Section 3-2
(AWG16 to AWG15)
COM OUT
Load
Output terminal