Input Specifications; Output Specifications - Omron ZG2 Series User Manual

Item
Ratings Power supply voltage 21.6 V to 26.4 V DC (including ripple)
Current consumption 0.8 A max.
Insulation resistance Across all lead wires and Controller case: 20 MΩ (by 250 V megger)
Dielectric strength
Operation Ambient temperature Operating: 0 to +50°C Storage: -15 to +60°C
environment
robustness
Ambient humidity
Degree of protection IP20 (IEC60529)
Vibration resistance
(durability)
Shock resistance
(destructive)
Material
Cable length
Weight
Accessories
*1 The measurement cycle stated here is for when the FIXED/AUTO sensitivity modes are selected. The
measurement cycle increases when the MULTI sensitivity/high-speed MULTI sensitivity mode is selected and
according to other settings. Also, when the high power mode is set to ON, the shortest measurement cycle
becomes 95 ms regardless of the CCD mode setting. Check the actual measurement cycle by the ECO
monitor in the RUN mode.
Controller signal statuses

Input specifications

LD-OFF
ZERO-RESET
TRIG

Output specifications

ALL-PASS
NG
ERROR
GATE
204
Specifications and External Dimensions
ZG2-WDC11/WDC11A
Across all lead wires and Controller case, 1000 V AC, 50/60 Hz, 1 min
(with no icing or condensation)
Operating and storage: 35% to 85%
Vibration frequency: 10 to 150 Hz Single-amplitude: 0.35 mm
Acceleration: 50 m/s
2
150 m/s 3 times each in 6 directions (up/down, left/right, forward/
backward)
Case: Polycarbonate (PC), Cable sheath: heat-resistant PVC
2 m
Approx. 300 g (including cable) (when packaged: approx. 450 g)
ZG2-WDC_1: ferrite core (large) (1 p'ce), Insure Lock (1 p'ce), Instruction
Sheet
ZG2-WDC_1A: ferrite core (large) (1 p'ce), ferrite core (small) (2 p'ces),
Insure Lock (1 p'ce), Instruction Sheet, setup software (CD-ROM), USB
cable
FUN mode ADJ mode
Enabled Enabled
Disabled Disabled
Disabled Disabled
FUN mode ADJ mode
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ZG2-WDC41/WDC41A
2
10 times for 8 minutes
RUN mode
Continuous
(trigger disabled)
Enabled
Enabled
Disabled
RUN mode
Continuous
(trigger disabled)
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Trigger
Enabled
Enabled
Enabled
Trigger
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ZG2 User's Manual