Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual page 208

Screen Configuration
Set the Segment Program 2 collection
cycle and the operation for when the
CX-Process Monitor Plus is restarted.
Set the ITEM for data collection in the
Segment Program 2 Screens.
• Click a box. The following dialog box
will be displayed.
• Select (1) for the tag name for the
function block (including the analog
ITEM to be registered), or (2) for the
tag name for the analog ITEM or
contact ITEM to be registered. In this
example, the tag name for the
function block is specified.
When a Segment Program 2 tag is
selected, nothing but that tag can be
selected.
• As shown on the screen to the right,
one tag can be allocated for one
optional tag for Segment Program 2.
4. Set the screen name.
5. Set the Segment Program 2 Screen basic settings as shown below.
Select the Segment
Program 2 collection cycle
(1, 10, or 60 s).
6. Select the Segment 2 Program to be monitored on the Segment 2 Program
Monitor Screen, and if required select an optional tag. After selecting the
tag, set Detail as described below.
Input the Segment Program 2 Screen name, using up
to 16 characters.
Make the settings for automatically saving segment data collection results
as CSV files when segment data collection is finished.
Select the operation for when the CX-Process Monitor Plus is
restarted while the Segment Program 2 Block S1 (ITEM 013)
is ON.
• Selected:
Continue collecting data to the same Segment Program 2
trend file when the CX-Process Monitor Plus is restarted.
• Not selected:
Begin collecting data to a new Segment Program 2 trend file
when the CX-Process Monitor Plus is restarted.
Section 5-5
193