Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual page 200

Screen Configuration
Select the box. The following dialog box
will be displayed.
Select the tag name corresponding to
the function block, analog ITEM, or
contact ITEM you want to register, and
then click the OK Button.
As shown in the screen on the right, you
can allocate up to eight tag names.
3. Select Control screen, and then click the New Button.
The following dialog box will be displayed.
You can register up to eight function blocks in the Control Screen. Specify
the function blocks using tag names.
When you select a tag name, the Details Button is enabled.
Select the box. The following dialog box will be displayed.
Make the settings, and then click the
OK Button.
The Manual Pointer and MV
direction settings will be reflected in
the MV adjustment area in the lower
part of the instrument diagram.
Refer to the next page for details of
displays.
Section 5-5
Enter the name of the
Control Screen using16
characters.
Deletes the
registered Tags.
When you
register a Tag,
the button is
enabled.
When you select this box, the
Manual Pointer is not
displayed. Refer to the next
page for details of displays.
Select this box, and then
select the direction MV will
open. If you do not specify a
direction, no direction will be
displayed. Refer to the next
page for details of displays.
Displays the settings
made using
CX-Process Tool. You
cannot change the
settings.
Select this box to set the
Prominent Tag. When setting the
Prominent Tag, the following mark
will be added to the icon on the
Overview Screen, as shown.
185