Outline; Using The Cx-Process Monitor Plus - Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual

Outline

4-1

Outline

1,2,3...
4-2

Using the CX-Process Monitor Plus

Preparations on the CX-Process Tool
1,2,3...
Operations on the CX-Process Monitor Plus
74
This section explains the functions and operations for each screen primarily
for those people who will operate CX-Process Monitor Plus. The explanations
assume that CX-Process Tool settings and screen configuration for the CX-
Process Monitor Plus have already been completed.
Refer to SECTION 5 Configuration Screens for how to configure CX-Process
Monitor Plus screens. Also, refer to the CX-Process Tool Operation Manual
(W372) for CX-Process Tool settings.
CX-Process Monitor Plus screen configuration is already completed, monitor
the Loop Control Unit/Board mainly by performing the following operations.
1. Start CX-Process Monitor Plus (refer to 4-4 Starting and Stopping the CX-
Process Monitor Plus).
2. In the CX-Process Monitor Plus Main Window, click the Run Button to dis-
play the Overview Screen (refer to 4-5 Overview Screen).
3. From the Overview Screen, move to each of the following screens.
• Control Screen (see 4-7 Control Screens)
• Tuning Screen (see 4-8 Tuning Screens)
• Trend Screen (see 4-9 Trend Screens)
• Batch Trend Screen (see 4-10 Batch Trend Screens)
• Segment Program 2 Screen (see 4-11 Segment Program 2 Screens)
• Graphic Screen (see 4-12 Graphic Screens)
• Annunciator Screen (see 4-13 Annunciator Screens)
• Operation Guide Screen (see 4-14 Operation Guide Screens)
• Alarm Log Screen (see 4-15 Alarm Log Screens)
• Operation Log Screen (see 4-16 Operation Log Screens)
• System Monitor Screen (see 4-17 System Monitor Screens)
• System Monitor Log Screen (see 4-18 System Monitor Log Screens)
1. Set the network address, node address, and unit address.
2. Register the function blocks for data exchange with the CX-Process Mon-
itor Plus.
3. Set CSV tags and tags for the CX-Process Monitor Plus.
4. Generate the tag file for Monitor Plus.
5. Download the function block data to the Loop Control Unit/Board.
6. Start the CX-Process Monitor Plus.
7. In the Main Window, click the Run Button to compile the monitor tag file.
(See note.)
8. In the Overview Screen, select Control Screen, Trend Screen, etc. as re-
quired.
Note Steps 7. will not be required and a specified screen will be displayed if auto-
starting is enabled. Autostarting can be enabled by clicking the System Info.
Button when configuring the screen and then setting the Auto-start–Auto-start
setting to Enable.
Section 4-1