Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual page 202

Screen Configuration
Select the Trend type.
Click the box. The following dialog box
will be displayed.
Select a) the tag name for the Function
Block (including the analog ITEMs you
want to register), or b) the tag name for
the for the analog ITEMs or contact ITEMs
you want to register. In this example, the
tag name for the Function Block for a) has
been specified.
As shown in the screen on the right, you
can allocate up to eight tag names.
Select the box. The following dialog box
will be displayed.
Select the Tag ITEM corresponding to
the analog ITEM you want to register. In
this example, Tag ITEM PV" for the
Function Block for tag name 4B009 has
been selected.
4. Enter the Screen Name, set the Trend Type, and then select Tag No.
When you register the tag name, the dialog box will change as follows:
5. Set Configure Tag No., Tag ITEM, and Detailed Settings, and then click
the OK Button.
Please a check here to enable automatically
saving a CSV file. When automatic saving
has been enabled, the save period (time),
save destination folder, save file name, and
browse button will be enabled.
Enter the name of the Overview
Screen using 16 characters.
Deletes the registered tags. When
you register a tag, the button is
enabled.
Select the box. The following dialog box will be
displayed.
Normally, there is no need to make settings because
they are set automatically.
Part of the data (PID constants, etc.), however, may not
match the display on the chart. Set the settings for the
High Limit and Low Limit for this data only.
Section 5-5
187