Omron SYSDRIVE 3G3MV SERIES User Manual page 334

List of Parameters
Param- Regis- Name
eter ter No.
No. (Hex)
n168 01A6 Output open-
phase detec-
tion level
(See note 1.)
n169 01A6 Output open-
phase detec-
tion time (See
note 1.)
n170 01AA Enter Com-
mand Opera-
tion Selection
n171 --- Not used
n172
n173 01AD Proportional
Gain for DC
Control
n174 01AE Integral Time
Constant for
DC Control
Note 1. Available for 5.5-kW and 7.5-kW Inverters only.
Note 2. These parameters are available on 200-V/400-V, 4.0-kW (or less) Inverters (software version
VSP010024 or higher) or 5.5-kW/7.5-kW Inverters (VSP010104 or higher).
10-32
Description
Sets as a percentage the current for
detecting an output open phase, tak-
ing the Inverter's rated output current
as 100%.
If "0" is set, the output open-phase
detection function will be disabled.
Recommended setting: 5 (%)
Sets the output open-phase detection
time in units of seconds.
If "0" is set, the output open-phase
detection function will be disabled.
Recommended setting: 0.2 (s)
Select the treatment of the Enter
command for momentay power inter-
ruptions.
0: Accept Enter command only when
operation is stopped.
1: Accept Enter command at any
time.
* Changed parameters are enabled
even if the Enter command is not
sent, but the changes will be lost if
power is reset if the Enter com-
mand has not been sent.
---
Normally use this parameter at the
default setting.
Normally use this parameter at the
default setting.
Chapter 10
Set- Unit Default Changes
ting of setting
range set-
ting
0 to 1 % 0 No
100
0.0 to 0.1 s 0.0 No
2.0
0 to 1 1 0 No
--- --- --- ---
1 to 1 83 No
(0.001)
999 (0.083)
10 (See
note 2.)
1 to 1 No
0
(100 ms)
250 (4 ms)
10 (See
note 2.)
Ref-
during er-
opera- ence
tion page
6-47
6-47
7-18
---
---
---