Mirus for H2/H3 Graingage User's Guide
CAUTION: This cannot be undone! Resetting the GrainGage to factory defaults will
clear all your settings, including actuator timers and weight calibrations. This should
only be done in consultation with a HarvestMaster Field Service Engineer.
Update the GrainGage Firmware
This option can be found on the Setup > H2 or H3 GrainGage > Firmware screen.
As an operator, you are not likely to need this screen. When you install or update Mirus,
the program will check for the latest firmware and update it automatically. The purpose
of this screen is to help HarvestMaster Field Service Engineers during troubleshooting
procedures.
The moisture curve option is covered in detail in
Moisture Curve and Chamber
Calibration
Wizard.
Export SCiO Files
This option can be found on the Setup > H3 GrainGage > SCiO screen.
You can zip the raw scan files that could be used for post-processing here if needed.
2. Mirus and GrainGage Setup
29