Table of Contents
Advertisement
Mirus for H2/H3 Graingage User's Guide
Load Cell
Coefficients
Slope and
Motion
Compensation
Trip Point
Weigh Time
Weight Tare
Warning
Note: Preconfigured values are default values based on generalized harvest conditions.
They may not reflect the optimum settings for the harvest conditions for your particular
climate, fields, or grains. Changing default values requires a certain level of experience.
Please contact HarvestMaster Field Service Engineers when adjusting these settings.
See Contact a HarvestMaster Field Service
Configure Test Weight Sensors
On the Setup > H2 or H3 GrainGage > Sensors screen,
1.
Tap Test Weight.
Mirus opens the Test Weight Sensor Setup screen on which you can configure test
weight settings for the GrainGage.
2. Mirus and GrainGage Setup
This setting overrides the open state time for the
top and bottom gates.
Caution: Wetter grain or oil seeds may require
longer evacuation times. Low-volume inserts will
also require a longer evacuation time. If this
setting is inaccurate, it may increase the
weighing cycle time unnecessarily or cause the
mixing of two plots.
The default values for load cell coefficients are
placeholders.
These are custom values that are generated
2.000
during weight calibration. They are used to
convert millivolt readings from the load cells into
pounds or kilograms.
Do not adjust these manually.
This corrects weight errors resulting from
Yes
movement and vibration as well as harvesting on
a slope.
The percentage of full bucket capacity at which a
80%
weight trip cycle will occur.
The period over which weight readings are
averaged. Although a shorter weigh time will
1000 msec
shorten cycle times, it may reduce the accuracy
of the measurement.
0.500 lb
This is the threshold above which a tare warning
(0.227 kg)
is generated after weigh bucket evacuation.
Engineer.
25
Advertisement
Table of Contents
