Mirus for H2/H3 Graingage User's Guide
Configure the GrainGage System Settings
On the Setup > H2 or H3 GrainGage screen,
1.
Tap System.
Mirus opens the System Setup screen where you can configure settings for the
GrainGage.
The following table displays the typical preferred setting for each item on this screen.
Item
Default Value
Debug
Streaming
Yes
Enabled
GrainGage
Classic
Type
Isolation
Normally
Gate Mode
Open
Max Sub-
1
Cycle Count
Enable SCiO
Yes
Data Sync
Reset the GrainGage to Factory Settings
This option can be found on the Setup > H2 or H3 GrainGage > Factory Reset screen.
2. Mirus and GrainGage Setup
System Settings
This enables or disables debug streaming
messages for the DSP module.
HarvestMaster recommends leaving this enabled.
Designates which GrainGage type is connected
to Mirus.
Controls the initial state of the isolation gate.
The maximum number of sub-cycles that will be
run during a cycle if the minimum weight
threshold continues to be satisfied.
H3 SCiO scan data will be backed up to the cloud
upon connecting to the internet.
Description
28