Configure Cycle Settings - Juniper HarvestMaster mirus H2 Classic GrainGage User Manual

Mirus for H2/H3 Graingage User's Guide
Start/Cycle/Countdown/Go Button: Start initiates harvest. Cycle
initiates measurements and data collection for a specific plot.
Countdown initiates a delay before measurements. Go indicates it's
time to move to the next plot.
Diagnostics: Opens the Diagnostics dialog box for monitoring during harvest.
Cycle Settings: Allows the operator to change the Mode, Button Type, Position,
and Countdown time for the Start/Cycle/Countdown/Go button.
Navigation: Opens the Change Location dialog box and allows the operator to
make changes to location, direction, and navigation type.
Observations: Opens a dialog box in which the operator can record notes for each
plot during harvest. This is also where you can add information about any traits
you configured.
Graph View: Displays accumulating data as a graph.
Quad View: Divides the display into four smaller windows. The operator can
adjust the size of each window and customize them each to display data in Cycle
Data, Diagnostics, Graph, Info, List, Spatial, or Real Time Weight view. This
screen should be used during your harvest.
Map View: Opens the Spatial Display, also referred to as a heat map. This display
can be configured to show attribute data plot by plot.
List View: Displays accumulating data as a list.
Ten Key: Numeric keypad for fast entry of trait and note data.

Configure Cycle Settings

The cycle settings determine the settings of the Start/Cycle/Countdown/Go button.
These settings can change the Countdown Mode, Button Type, Toolbar Position, and the
Countdown Time.
7. Harvest Mode 136