Flats On Shafts - Dürkopp Adler D867 e-con Service Instructions Manual

Working basis

3.7 Flats on shafts

Fig. 20: Flats on shafts
(1) - Flat
Some shafts have flat surfaces at the points where the components are
screwed on. This stabilizes the connection and makes adjusting easier.
Important
Always ensure that the screws are completely flush with the surface.
The rule is to always place the 1
the flat.
Service Instructions D867 e-con - 00.0 - 08/2023
NOTICE
Property damage may occur!
An incorrect setting can result in damage to the machine.
Always place the first screw in rotational direction onto the flat.
①
②
(2) - Shaft
st
screw in rotational direction onto
31