Table of Contents
Advertisement
5. Lower presser foot (2) and walking foot (1) to the level of the throat
6. Re-tighten the screw (3).
7. Switch on the machine.
8. Call up the service routine Sewing foot stroke > Equal sewing
The software is used to define the necessary presettings on the
9. Use
10. Press the
11. Finish the service routine.
Checking the setting
To check the setting:
1. Set the sewing foot stroke to 3 in the seam program.
2. Press the Service Stop button.
3. Use a 3 mm allen key to check if the stroke is identical when the sewing
4. Readjust if necessary.
10.3 Adjusting the sewing foot pressure and sewing foot lift
Fig. 54: Adjusting the sewing foot pressure and sewing foot lift (1)
(1) - Locking peg
68
plate.
foot stroke ( p. 14).
machine.
and
to fine-tune the settings.
button.
foot is at the top dead center.
①
Service Instructions D867 e-con - 00.0 - 08/2023
Sewing feet
Advertisement
Table of Contents
