Working basis
3.8 Locking the machine in place
For some adjustments, the machine must be locked in place at the looping
stroke position. The position corresponds to handwheel position 202°.
To do this, insert the locking peg included in the accessories into the slot
on the arm shaft crank, blocking the arm shaft.
Fig. 21: Locking the machine in place
①
①
(1) - Locking peg
Locking the machine in place
To lock the machine in place:
1. Insert the locking peg (1) through the slot in the machine arm.
2. Turn the handwheel carefully until the locking peg (1) slides into
the slot on the arm shaft crank.
Removing the lock
To remove the lock:
1. Pull the locking peg (1) out of the slot in the machine arm.
32
Service Instructions D867 e-con - 00.0 - 08/2023