7.5 Aligning the feed dog in sewing direction
Order
Start by aligning the needle bar linkage in the sewing direction ( p. 49).
Fig. 36: Aligning the feed dog in sewing direction
(1) - Screw
To align the feed dog in the sewing direction:
1. Execute the service routine Feed dog > Position to
The software is used to define the necessary presettings on
2. Open the throat plate slide ( p. 28).
3. Tilt the machine head ( p. 18).
4. Loosen the screw (2).
5. Align the lever such that the distance between lever and block is
6. Tighten the screw (2).
7. Loosen the screw (1).
8. Align the feed dog in the sewing direction such that the needle pierces
9. Tighten the screw (1).
Order
Next, check the feed movement to the throat plate cutout at the maximum
stitch length.
50
needle ( p. 14).
the machine.
0.5 mm.
in the center of the needle hole.
Adjusting feed dog and needle bar linkage
①
(2) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
0.5 mm
②