12.2 Adjusting the winder filling quantity
Proper setting
The winding process will stop automatically when the required filling
quantity of the bobbin is reached.
Fig. 62: Adjusting the winder filling quantity
(1) - Bobbin winder lever
To adjust the winder filling quantity:
1. Move the winder lever (1):
2. Check the winder filling quantity by carrying out a winding process and
Information
To keep the thread from overflowing on the bobbin, observe the following
setting tolerances:
• Bobbin Ø 32 mm: Ø 31 ± 0.5 mm
• Bobbin Ø 28 mm: Ø 27 ± 0.5 mm
76
①
②
• Filling quantity too low: Loosen the threaded pin (2).
• Filling quantity too high: Screw in the threaded pin (2).
correct the setting if necessary.
(2) - Threaded pin
Service Instructions D867 e-con - 00.0 - 08/2023
Bobbin winder