Table of Contents
Advertisement
How To....
Replace the Motor Control Board
Tools Required: Phillips Screwdriver
Estimated Repair Time: 30 minutes
1. Turn the cross trainer power switch OFF.
2. Unplug the line cord from the wall outlet.
3. Remove and save the fi ve screws that secure the front right rear shroud to the frame.
4. Disconnect all cables connected to the motor control board. Note where each cable plugs into the board. This will
simplify reassembly.
5. To remove the motor control board, squeeze the four plastic standoffs on the mounting plate.
6. Install the new motor control board in reverse order.
Mounting Plate
Motor
Control Board
Plastic Standoff (4)
Motor
Control Board
Back of Plastic Standoff
(squeese to release)
Exploded View
Back of Mounting Plate
38
Advertisement
Table of Contents
