Life Fitness E5 Service Manual page 44

How To....
Calibrate the Eddy Current Brake and Servo Motor (continued)
8. Clip the end fi tting of the brake cable housing into the slot at the bottom of the slide block channel.
9. Plug the power back into the machine. The servo motor should move to the Level 1 resistance position after the
console initializes.
10. Turn the adjustment nut on the brake cable until the top of the slide block is between the two lines on the brake
housing. See Figure 6.
11. Start a Manual Program and move the resistance up to Level 20 and back down to Level 1. Check to be sure the
top of the slide block is still between the two lines on the eddy current brake housing. There must be a gap be-
tween the bottom of the slide block and the end fi tting on the cable housing or the console will display an error.
Readjust the nut if needed and then lock in place with the jam nut.
12. Reinstall the shrouds.
Must be a
gap here
43
Between these
lines
Figure 6