Life Fitness E5 Service Manual page 34

6. Remove and save the bolt and washer that secure the idler assembly to the main
frame.
7. Pull the cable out of the main frame tube. Remove and save the bolt that secures
the other end of the idler assembly to the actuator bracket.
8. Remove and save the bolt that secures the other end of the idler assembly to the
actuator bracket.
9. Route the new idler assembly cable through the main frame tube. The cable is
pre-installed in the new idler.
10. Connect the cable to the motor control board.
11. Route the other end of the cable through the inside actuator shroud. Be sure to
route the cable as shown below.
12. Connect the cable to the actuator.
13. Install the new idler assembly using the hardware removed and saved in the previous steps.
Cable must be
routed under
screw boss on
shroud
Cable must not be pulled tight
against actuator.
Minimum 1/2" gap required.
33
Bolt
Actuator Bracket