Lldp-Med Location - ZyXEL Communications XMG1915 Series User Manual

Figure 141 PORT > LLDP > LLDP MED > LLDP-MED Network Policy > Add/Edit
The following table describes the labels in this screen.
Table 105 PORT > LLDP > LLDP MED > LLDP-MED Network Policy > Add/Edit
LABEL
Port
Application Type
Tag
VLAN
DSCP
Priority
Apply
Clear
Cancel

33.10 LLDP-MED Location

Click PORT > LLDP > LLDP MED > LLDP-MED Location to display the screen as shown next.
Chapter 33 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Enter the port number to set up the LLDP-MED network policy. You can enter multiple ports
separated by (no space) comma (",") or hyphen ("-") for a range. For example, enter "3-5"
for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Select the type of application used in the network policy.
• voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Select to tag or untag in the network policy.
• tagged
• untagged
Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter "0".
Enter the DSCP value of the network policy. The value is defined from 0 through 63 with the 0
representing use of the default DSCP value.
Enter the priority value for the network policy.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
203