Ipv6 Prefix Setup - ZyXEL Communications XMG1915 Series User Manual

Figure 103 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Router Discovery Setup > Edit
The following table describes the labels in this screen.
Table 62 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Router Discovery Setup > Edit
LABEL
Interface
Flags
Minimum Interval
Maximum Interval
Lifetime
Suppress
Apply
Clear
Cancel

24.9 IPv6 Prefix Setup

Use this screen to configure the Switch's IPv6 prefix list for each interface. Click SYSTEM > IPv6 > IPv6
Neighbor Discovery > IPv6 Prefix Setup to display the screen as shown next.
Chapter 24 IPv6
DESCRIPTION
Select the IPv6 interface you want to configure.
Select the Managed Config Flag option to have the Switch set the "managed address
configuration" flag (the M flag) to 1 in IPv6 router advertisements, which means IPv6 hosts
use DHCPv6 to obtain IPv6 stateful addresses. De-select the option to set the flag to 0 and
the host will not use DHCPv6 to obtain IPv6 stateful addresses.
Select the Other Config Flag option to have the Switch set the "Other stateful
configuration" flag (the O flag) to 1 in IPv6 router advertisements, which means IPv6 hosts
use DHCPv6 to obtain additional configuration settings, such as DNS information. De-select
the option to set the flag to 0 and the host will not use DHCPv6 to obtain additional
configuration settings.
Specify the minimum time interval (from 3 to 1350 seconds) at which the Switch sends
router advertisements for this interface.
Note: The minimum time interval cannot be greater than three-quarters of the
maximum time interval.
Specify the maximum time interval (from 4 to 1800 seconds) at which the Switch sends
router advertisements for this interface.
Specify how long (from 0 to 9000 seconds) the router in router advertisements can be used
as a default router for this interface.
Enable the switch button to set the Switch to not send router advertisements and
responses to router solicitations on this interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
149