Diagnostic - ZyXEL Communications XMG1915 Series User Manual

Table 203 MAINTENANCE > Configuration > Configure Clone (continued)
LABEL
NETWORKING
SECURITY
Apply
Cancel

60.13 Diagnostic

Click MAINTENANCE > Diagnostic in the navigation panel to open this screen. Use this screen to ping IP
addresses, run a traceroute, perform port tests or show the Switch's location between devices.
Figure 266 MAINTENANCE > Diagnostic
The following table describes the labels in this screen.
Table 204 MAINTENANCE > Diagnostic
LABEL
Ping Test
IPv4
Chapter 60 MAINTENANCE
DESCRIPTION
Select the networking feature (you configured in the NETWORKING menus) to be copied to the
destination ports. Otherwise, select the NETWORKING check box in the table heading row to
select all features for a category.
Select which security features (you configured in the SECURITY menus) should be copied to the
destination ports. Otherwise, select the SECURITY check box in the table heading row to select all
features for a category.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select this option if you want to ping an IPv4 address. Otherwise, select – to send ping
requests to all VLANs on the Switch.
XMG1915 Series User's Guide
364