Add/Edit Poe Time Range - ZyXEL Communications XMG1915 Series User Manual

Table 110 PORT > PoE Setup > PoE Time Range Setup (continued)
LABEL
Add/Edit
Delete

34.3.1 Add/Edit PoE Time Range

To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit
button.
Figure 148 PORT > PoE Setup > PoE Time Range Setup > Add/Edit
The following table describes the labels in this screen.
Table 111 PORT > PoE Setup > PoE Time Range Setup > Add/Edit
LABEL
Port
Time Range
Apply
Clear
Cancel
Chapter 34 PoE Setup
DESCRIPTION
Click Add/Edit to add a new rule or edit a selected one.
Check the rules that you want to remove and then click the Delete button.
DESCRIPTION
Enter the number of the port to which you want to apply a schedule.
This field displays the name of the schedule that you have created using the SYSTEM > Time
Range screen.
Select a pre-defined schedule to control when the Switch enables PoE to provide power on
the port. To select more than one schedule, press [SHIFT] and select the choices at the same
time.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
213