Add/Edit Dhcpv4 Global Relay Port - ZyXEL Communications XMG1915 Series User Manual

Figure 207 NETWORKING > DHCP > DHCPv4 Relay > DHCP Smart Relay
The following table describes the labels in this screen.
Table 165 NETWORKING > DHCP > DHCPv4 Relay > DHCP Smart Relay
LABEL
DHCP Smart Relay
Active
Remote
DHCP Server
1 .. 3
Option 82
Profile
Apply
Cancel
Port
Use this section to apply a different DHCP option 82 profile to certain ports on the Switch.
Index
Port
Profile Name
Add/Edit
Delete

51.5.1 Add/Edit DHCPv4 Global Relay Port

Use this screen to apply a different DHCP option 82 profile to certain ports on the Switch. To open this
screen, Click Add/Edit, or select an entry and click Add/Edit in the Port section of the NETWORKING >
DHCP > DHCPv4 Relay > DHCP Smart Relay screen.
Chapter 51 DHCP
DESCRIPTION
Select this check box to enable DHCPv4 relay.
Enter the IP address of a DHCPv4 server in dotted decimal notation.
Select a pre-defined DHCPv4 option 82 profile that the Switch applies to all ports. The Switch
adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to DHCP
requests that it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays a sequential number for each entry.
This field displays the ports to which the Switch applies the settings.
This field displays the DHCP option 82 profile that the Switch applies to the ports.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XMG1915 Series User's Guide
295