Priority Queue; Chapter 43 Priority Queue; Priority Queue Overview; What You Can Do - ZyXEL Communications XMG1915 Series User Manual

43.1 Priority Queue Overview

IEEE 802.1p defines up to eight separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service. Frames without an explicit priority tag are given the default
priority of the ingress port. Use this screen to configure the priority level-to-physical queue mapping. The
Switch has eight physical queues that you can map to the eight priority levels.
On the Switch, traffic assigned to higher index queues gets through faster while traffic in lower index
queues is dropped if the network is congested.

43.1.1 What You Can Do

Use the Priority Queue screen
queue mapping.

43.2 Assign Priority Queue

Use this screen to assign priority level to each queue.
Click SWITCHING > QoS > Priority Queue to open this screen.
Figure 168 SWITCHING > QoS > Priority Queue

Chapter 43 Priority Queue

Priority Queue

(Section 43.2 on page 238) to configure the priority level-to-physical
XMG1915 Series User's Guide
238
C
H A P T E R
43