Ipv6 Neighbor Setup - ZyXEL Communications XMG1915 Series User Manual

Table 64 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Prefix Setup > Add/Edit (continued)
LABEL
Prefix Length
Valid Lifetime
Preferred Lifetime
Flags
Apply
Clear
Cancel

24.10 IPv6 Neighbor Setup

Use this screen to view and configure static IPv6 neighbor entries in the Switch's IPv6 neighbor table to
store the neighbor information permanently. Click SYSTEM > IPv6 > IPv6 Neighbor Setup to display the
screen as shown next.
Figure 106 SYSTEM > IPv6 > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 65 SYSTEM > IPv6 > IPv6 Neighbor Setup
LABEL
Index
Interface
Neighbor
Address
MAC
Add/Edit
Delete
Chapter 24 IPv6
DESCRIPTION
Set the prefix length that the Switch includes in router advertisements for this interface.
Specify how long (from 0 to 4294967295 seconds) the prefix is valid for on-link
determination.
Specify how long (from 0 to 4294967295 seconds) that addresses generated from the prefix
remain preferred.
The preferred lifetime cannot exceed the valid lifetime.
Select No-Autoconfig Flag to not allow IPv6 hosts to use this prefix.
Select No-Onlink Flag to not allow the specified prefix to be used for on-link determination.
Select No-Advertise Flag to set the Switch to not include the specified IPv6 prefix, prefix
length in router advertisements for this interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This is the interface index number.
This is the name of the IPv6 interface you created.
This field displays the IPv6 address of the neighboring device which can be reached through the
interface.
This field displays the MAC address of the neighboring device which can be reached through the
interface.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XMG1915 Series User's Guide
151