Table of Contents
Advertisement
Figure 122. Installing a fan board
Next steps
1.
Install the cooling
fans.
2.
Install the 1U air
shroud.
3.
Install the 2U air
shroud.
4. Follow the procedure listed in
M.2 BOSS card
Removing BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4. If installed, remove the
5. If installed,
remove the Expansion card riser
NOTE:
The procedure to remove the BOSS riser is the same for Rear Accessed and Front Accessed configurations.
Steps
Holding the blue touch points lift the BOSS riser from the riser connector on the system board.
150
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
Expansion card riser
2.
1.
system.
system.
Advertisement
Table of Contents
