Table of Contents
Advertisement
Table 1. Features available on the front view of Front Accessed E3.S configuration
Item
1
2
3
4
5
6
7
8
9
10
Ports, panels, or slots
Status LED control panel
PCIe expansion card riser 1
(slot 1)
PCIe expansion card riser 1
(slot 2)
PCIe expansion card riser 2
(slot 3)
PCIe expansion card riser 2
(slot 4)
Drive
Power button control panel
Power supply unit (PSU 2)
and (PSU 1)
System identification button
VGA port
Icon
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Description
Contains the system health,
system ID, status LED.
● Status LED: Enables you
to identify any failed
hardware components.
There are five status LEDs
and an overall system
health LED (Chassis health
and system ID) bar. For
more information, see
the
Status LED indicators
section.
Enables you to connect PCI
Express expansion cards.
Enables you to connect PCI
Express expansion cards.
Enables you to connect PCI
Express expansion cards.
Enables you to connect PCI
Express expansion cards.
Enables you to install up to 4
x 2.5-inch, or 8 x E3.S Solid-
State Drives (SSDs)
Contains the power button,
USB port, iDRAC Direct micro
USB port, and the iDRAC
Direct status LED.
Indicates the PSU2
(redundant PSU) and PSU1
(primary PSU)
Press the system ID button:
● To locate a particular
system within a rack.
● To turn the system ID on
or off.
To reset iDRAC, press and
hold the button for 16
seconds.
NOTE:
● To reset iDRAC using
system ID, ensure that
the system ID button is
enabled in the iDRAC
setup.
● If the system stops
responding during
POST, press and hold
the system ID button
(for more than five
seconds) to enter the
BIOS progress mode.
Enables you to connect a
display device to the system.
System overview
11
Advertisement
Table of Contents
