Installing the Status LED control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the 1U air
shroud.
5. Remove the
Expansion card riser
6. Remove the
Expansion card riser
NOTE:
The procedure to install the Status LED control panel is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Route the control panel cable through the guide slots in the system and connector on system board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the Status LED control panel assembly in the slot on the system.
3. Using the Torx 8, tighten screws from status LED control panel assembly.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 166. Installing the Status LED control panel for Front Accessed configuration
Safety
instructions.
Before working inside your
2.
1.
system.
Installing and removing system components
191