Table of Contents
Advertisement
Figure 155. Removing the power interposer board
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive
cage.
4.
Remove the 2U air
shroud.
5.
Remove the power supply units
6. Disconnect the cables that are connected to power interposer board (PIB) including intrusion switch module cable and from
the system board.
NOTE:
The procedure to install the PIB is same for Rear Accessed and Front Accessed configurations.
Steps
1. Align the slots on the PIB with the hook on the chassis and slide it into place.
2. Using Phillips 2 screwdriver, tighten the screws to secure the PIB to the system.
180
Installing and removing system components
board.
Safety
instructions.
Before working inside your
(PSU).
system.
Advertisement
Table of Contents
